IKO Bathroom Remodeling in Las Vegas, NV

IKO Bathroom Remodeling: The Las Vegas Owner’s Guide

IKO bathroom remodeling in Las Vegas typically runs $9,000-$28,000 for a full replacement, and most jobs start within 2-3 weeks of your call. We stock IKO-compatible waterproofing membranes, underlayment systems, and drainage components, with same-day assessment available when water damage is active. Most Las Vegas homeowners realize something’s wrong when they spot bubbling near the tub surround, soft spots under vinyl flooring, or a musty smell that won’t clear out no matter how much they ventilate.

Call (855) 951-4361

Which IKO Models This Applies To

IKO doesn’t manufacture complete bathroom fixtures like tubs or vanities. What they build are the critical behind-the-wall and under-foot systems that keep bathrooms dry: ProArmor synthetic underlayment, AquaBarrier waterproofing membranes, and DrainRight drainage mats. These get specified by Las Vegas contractors for wet-area protection under tile, stone, and vinyl plank installations.

To identify what you’ve got, check the wall cavity if you have access, or look for IKO labeling on any exposed membrane at fixture cutouts. ProArmor has a bright orange face fabric; AquaBarrier is a gray, fleece-backed sheet membrane. The gotcha in older Las Vegas homes, especially anything built 1995-2010 in Summerlin or Henderson, is that some contractors used generic housewrap instead of proper wet-area membrane. It looks similar, but it isn’t rated for continuous moisture exposure. If you’re seeing degradation, that’s likely your culprit.

We install OEM IKO systems or equivalent-spec alternatives from brands like Silestone and Cambria when the project scope calls for integrated material packages. The choice depends on your existing warranty status and whether you’re doing a targeted repair or full gut.

Signs Your IKO Bathroom Remodeling Is Failing

• Soft or spongy flooring near the tub or shower. This means moisture has breached the membrane layer and saturated the subfloor. In Las Vegas, the dry climate actually accelerates wood rot once moisture gets in, because the rapid wet-dry cycling stresses adhesives and causes delamination faster than in consistently humid regions.
• Tile cracks or grout lines that won’t stay filled. Movement in the underlayment system, often from an IKO membrane that’s lost adhesion to the substrate, transfers flex stress straight to the finished surface. We see this most in second-story bathrooms where the original install didn’t account for deflection properly.
• Musty odor that persists after cleaning. Your nose is detecting microbial growth in the cavity. IKO AquaBarrier is mold-resistant, but if the seam tape failed or the membrane was punctured during fixture installation, organic material in the wall cavity becomes a problem fast.
• Water stains on ceiling below the bathroom. By the time you’re seeing this, the drainage plane has been compromised for a while. In single-story Las Vegas homes with slab foundations, this symptom won’t appear, which is why those installations often fail silently until the damage is extensive.
• Peeling paint or wallpaper outside the wet area. Capillary moisture migration through a failed membrane wicks horizontally, not just down. We’ve traced this back to a 3-inch tear in ProArmor behind a poorly mounted grab bar more than once in Green Valley homes.

Replacement Cost & What’s Included

A full IKO bathroom system replacement in Las Vegas falls in that $9,000-$28,000 range. Here’s what moves you up or down:

The lower end assumes accessible plumbing, standard 5×8 footprint, and no structural repair. The upper end covers larger master baths, custom shower builds, relocating fixtures, or subfloor replacement. Our quotes are upfront pricing, no surprises, itemized so you see exactly where the money goes. Every IKO system we install is covered by our 730-Day Done Right Promise, and we don’t disappear after the check clears.

DIY or Call Us?

Here’s where we’re straight with you. A homeowner can safely check for the obvious: look at exposed membrane edges, sniff for mustiness, press on flooring with a bare foot to feel for give. Take photos of any labeling you find. That’s useful intel, and it costs nothing.

But tearing into a wet wall to replace membrane? That’s where it goes sideways. You’re dealing with possible electrical runs in the cavity, structural load questions if the subfloor’s compromised, and the reality that IKO systems only work when every seam, penetration, and transition is detailed correctly. One missed seam and you’re back to square one in six months. We’ve rebuilt enough DIY “fixes” in Anthem and Seven Hills to know the pattern.

Our technicians are background-checked, uniformed, and they carry the full IKO-compatible inventory on the truck. Call (855) 951-4361 and a live person picks up, 24/7. We’ll get eyes on it, tell you exactly what’s happening, and quote it honestly.

FAQs